2011 (Installed 2013) Used 5-Axis Machining Center “QUASER” Model: MF-400C 5-Axis (4+1 Axis), Trunnion Type

With FANUC OiMD (4-Axis Simultaneous movement with any combination out of 5-axis.)

Caltec Concepts & Engineering


X-Axis: 16.1”
Y-Axis: 24”
Z-Axis: 20”
A-Axis: 150º
C-Axis: Full rotation
Table size: 12.5” dia.
Spindle speed: 10,000 RPM
Spindle taper: 40 TAPER
Spindle motor: 18 HP
Max. Workpiece: 15.&” Ø, 11.8” High
ATC: 30 tools, CT-40
Weight: 16,000 Lbs.
Floor Spacing: 98” x 111” 119”


  • 2-augers and lift up chip conveyor Spindle oil temperature controller.

FOB Dominguez Hills, CA

Caltec Concepts & Engineering
Caltec Concepts & Engineering
Caltec Concepts & Engineering
Caltec Concepts & Engineering
Caltec Concepts & Engineering

30 tools ATC, CT-40

Caltec Concepts & Engineering



Unless otherwise noted on the front page hereof, payment shall be 10% as a down payment with order, balance 90% shall be made by the Purchaser to CALTEC no later than 48 hours prior to the machine removal. Payment shall be by bank wire transfer, certified or cashier’s check, or Cash.


Item(s) are sold “As Is, Where Is” unless other arrangements have been made and conveyed in writing. There are no warranties, which extend beyond the description on the face hereof; quotation subject to change without notice.

All agreements and/or contracts made by sales person are subject to approval.


CALTEC provided machine specifications, equipment list, and manufactured year of machines on the front pages which are CALTEC’s best knowledge. It is the purchaser’s responsibility to inspect and confirm them prior to purchase.

CALTEC reserve the right to correct typographical errors on CALTEC’s documents.


It is the buyers/user’s responsibility to provide proper safety devices and equipment to safeguard persons from harm resulting from any particular use, operation, or set-up, and adequately safeguard the equipment to conform to all Federal, state, and Local Government Safety Standards and all Industrial Standards.


Buyer/User agrees to indemnify and hold harmless the Seller and Salesperson(s) from any and all claims or liabilities caused by or arising from the equipment on the face hereof.

It is the Purchaser's responsibility to verify the machine(s) condition and specifications and to pay any and all applicable taxes.