2012 USED “JAPANTEK /KASAHARA” 5-AXIS HORIZONTAL MACHINING CENTER MODEL: 5X-410

With FANUC 31iM-A5 5-axis control

Capture12

SPECIFICATIONS:

Pallet table size: 16.1” x 16.1”
Number of pallets: 2-sets
Pallet load: 1,320 Lbs.
X Axis Travel: 25.6”
Y-axis Travel: 25.6”/Horizontal spindle, 40.9”/Vertical spindle
Z Axis Travel: 24”
A-AXIS Travel: 90ᴼ +15ᴼ / -15ᴼ
B-AXIS Travel: Infinity
Rapid traverse: 1,418 ipm
Spindle speed: 12,000 rpm
Spindle motor: 30 hp
Spindle taper: CT-40
No. of ATC: 40 tools
Machine floor size:115” x 177” x 104”
Machine weight: 15,000 lbs

Low hours. CA

PRICE: $97,500.00

Under the power for inspection.

FOB So. California.

Capture13

5-axis & 5 face machining

Capture17
Capture20

FANUC 31iM-A5

40 TOOLS ATC, CT-40

Capture21

TERMS & CONDITIONS

TERMS and PAYMENT :

Unless otherwise noted on the front page hereof, payment shall be 10% as a down payment with order, balance 90% shall be made by the Purchaser to CALTEC no later than 48 hours prior to the machine removal. Payment shall be by bank wire transfer, certified or cashier’s check or Cash.

CONDITIONS :

Item(s) are sold “As Is, Where Is” unless other arrangements have been made and conveyed in writing. There are no warranties, which extend beyond the description on the face hereof; quotation subject to change without notice.

All agreements and/or contracts made by sales person are subject to approval.

SPECIFICATIONS & YEARS.

CALTEC provided machine specifications, equipment list and manufactured year of machines on the front pages which are CALTEC’s best knowledge..It is the purchaser’s  responsibility to inspect and confirm them prior to purchase.

CALTEC reserve the right to correct typographical errors on CALTEC’s documents.  

EQUIPMENT SAFETY :

It is the buyers / user’s responsibility to provide proper safety devices and equipment to safeguard persons from harm resulting from any particular use, operation or set-up, and adequately safeguard the equipment to conform to all Federal, state and Local Government Safety Standards and all Industrial Standards.

INDEMNIFICATION :

Buyer/User agrees to indemnify and hold harmless the Seller and Salesperson(s) from any and all claims or liabilities caused by or arising from the equipment on the face hereof.

It is the Purchasers responsibility to verify the machine(s) condition and specifications and to pay any and all applicable Taxes.