New 2018 “ANEST-IWATA” Japan, like NEW!!
CLASS ZERO Oil-Free Scroll Type 20 HP Air Compressor
SPECIFICATION: (from catalogue)
Control:Multiple unit control auto start/stop
Discharge Pressurel: 94-116 psi
Capacity: 60 cfm
Electrical Requirement: 208-230V/460V,3Ph ,60Hz
Air end revolution: 3200 rpm
Drive motor (4-sets of 5 HP motors): 20hp
Drive motor efficiency: 91.0%
Noise level58 dB(A)
Ground vibration (db): Less than 45
Compressed air discharge connection: 1 "NPT
Dimensions in inches (L x W x H): 26" x 38" x 62"
Estimated weight: 1,060 Lbs.
Operation manual & Electric schematic: Included
This compressor come with following equipment
USED LESS THAN 200 Hours, almost like new compressor.
Your investment: $22,500.00
ANEST IWATA CLASS ZERO OILFREE AIR COMPRESSOR
OIL LESS RECIPROCATING
OIL LESS SCROLL TANK MOUNT
OIL LESS SCCROLL ENCLOSURE
GREAT FEAURE FOR YOUR LIFE LINE
4-sets of independent 5 hp motor Drive system provide None-stop continuous air supply for keeping your life line live.
(1-motor stopped by some reason, but remaining 3-sets of motors suppling air conuously)
COMPLETE AIR COMPESSOR SYSTEM INCLUDED.
“ZEKS” CN Series Non-cycling Refrigeraed Air Dryer, Capacity: 11-64 SCFM
Refrigerated air dryer remove moisture from compressed air, auto water dranage.
“OPTIFLO”, Optimized Flow Controller
“ZEKS” COMPRESSED AIR FILTER
TERMS & CONDITIONS
TERMS and PAYMENT :
Unless otherwise noted on the front page hereof, payment shall be 10% as a down payment with order, balance 90% shall be made by the Purchaser to CALTEC no later than 48 hours prior to the machine removal. Payment shall be by bank wire transfer, certified or cashier’s check or Cash.
Item(s) are sold “As Is, Where Is” unless other arrangements have been made and conveyed in writing. There are no warranties, which extend beyond the description on the face hereof; quotation subject to change without notice.
All agreements and/or contracts made by sales person are subject to approval.
SPECIFICATIONS & YEARS.
CALTEC provided machine specifications, equipment list and manufactured year of machines on the front pages which are CALTEC’s best knowledge..It is the purchaser’s responsibility to inspect and confirm them prior to purchase.
CALTEC reserve the right to correct typographical errors on CALTEC’s documents.
EQUIPMENT SAFETY :
It is the buyers / user’s responsibility to provide proper safety devices and equipment to safeguard persons from harm resulting from any particular use, operation or set-up, and adequately safeguard the equipment to conform to all Federal, state and Local Government Safety Standards and all Industrial Standards.
Buyer/User agrees to indemnify and hold harmless the Seller and Salesperson(s) from any and all claims or liabilities caused by or arising from the equipment on the face hereof.
It is the Purchasers responsibility to verify the machine(s) condition and specifications and to pay any and all applicable Taxes.