2019 (Installed Nov. 2019) “QUASER” 5-AXIS VERTICAL MACHINING CENTER MODEL: MF-500U with Siemens 840D control
Used only 2 months.
SPECIFICATIONS:
Travel - Rapid / Feed rate
X Axis: 21.6” - 1417 ipm / 787 ipm
Y Axis: 31.5” - 1417 ipm / 787 ipm
Z Axis: 24.0” - 945 ipm / 787 ipm
A Axis: Tilt 150 degree (+30 – 120 degree)
C-Axis: rotate 360 degree continuous
MA Max workpiece envelop: 19.6” x 11.8”
Table size: 16.1” Ø
Table load: 440 Lbs.
Spindle motor: 18 HP H/L shifting
Spindle speed: 12,000 rpm
Spindle taper: CT-40 BigPlus
ATC: 30 tools, side mount double arm type
Machine Net Weight: 17,000lbs.
Power Consumption: 22 kVA
Floor Spacing: (W x D x H) 104”x 127” x 122”
EQUIPPED WITH:
The machine is used only less than 2 months, like Demo machine condition.
QUASER MF-500U 5-AXIS VERTICAL MACHINE
Less than 2 months used – like Demo machine condition
SIEMENS 840D 5-AXIS CONCTROL
TOOL MEASURMENT TOUTCH PROCE
30 TOOLS ATC, CT-40 BIG PLUS
CHIP CONVEYOR
OIL TEMPERATURE CONTROLLER FOR SPINDLE
TERMS & CONDITIONS
TERMS and PAYMENT :
Unless otherwise noted on the front page hereof, payment shall be 10% as a down payment with order, balance 90% shall be made by the Purchaser to CALTEC no later than 48 hours prior to the machine removal. Payment shall be by bank wire transfer, certified or cashier’s check or Cash.
CONDITIONS :
Item(s) are sold “As Is, Where Is” unless other arrangements have been made and conveyed in writing. There are no warranties, which extend beyond the description on the face hereof; quotation subject to change without notice.
All agreements and/or contracts made by sales person are subject to approval.
SPECIFICATIONS & YEARS.
CALTEC provided machine specifications, equipment list and manufactured year of machines on the front pages which are CALTEC’s best knowledge..It is the purchaser’s responsibility to inspect and confirm them prior to purchase.
CALTEC reserve the right to correct typographical errors on CALTEC’s documents.
EQUIPMENT SAFETY :
It is the buyers / user’s responsibility to provide proper safety devices and equipment to safeguard persons from harm resulting from any particular use, operation or set-up, and adequately safeguard the equipment to conform to all Federal, state and Local Government Safety Standards and all Industrial Standards.
INDEMNIFICATION :
Buyer/User agrees to indemnify and hold harmless the Seller and Salesperson(s) from any and all claims or liabilities caused by or arising from the equipment on the face hereof.
It is the Purchasers responsibility to verify the machine(s) condition and specifications and to pay any and all applicable Taxes.